KRYLON PRODUCTS GROUP,SPECIALTY DIV,DIV SHERWIN-WILLIAMS CO -- 7010 SPRAY ADHESIVE -- -
===================== Product Identification ===================== Product ID:7010 SPRAY ADHESIVE MSDS Date:08/20/1994 FSC:NIIN:Submitter:D DG Status Code:A === Responsible Party === Company Name:KRYLON PRODUCTS GROUP,SPECIALTY DIV,DIV SHERWIN-WILLIAMS CO Address:31500 SOLON ROAD City:SOLON State:OH ZIP:44139 Country:US Info Phone Num:800-797-3332/216-292-7400 Emergency Phone Num:216-292-7400 Resp. Party Other MSDS Num.:GA/K, SPECS/KRI CAGE:TO471 === Contractor Identification === Company Name:KRYLON PRODUCTS GROUP,SPECIALTY DIV,DIV SHERWIN-WILLIAMS CO Address:31500 SOLON ROAD City:SOLON State:OH ZIP:44139 Country:US Phone:800-797-3332/216-292-7400 CAGE:TO471 Company Name:NASCO INTL INC., NASCO DIV Address:901 JANESVILL AVE Box:City:FORT ATKINSON State:WI ZIP:53538-0901 Country:US Phone:920-563-2446 Contract Num:MDA414-98-A-0001-0332 CAGE:33089 ============= Composition/Information on Ingredients ============= Ingred Name:PROPANE (PROPELLANT) CAS:74-98-6 RTECS #:TX2275000 = Wt:11. OSHA PEL:1800 MG/M3;1000 PPM Ingred Name:2-METHYLPROPANE (PROPELLANT) CAS:75-28-5 RTECS #:TI4300000 = Wt:14. Ingred Name:HEXANE CAS:110-54-3 RTECS #:MN9275000 = Wt:35. OSHA PEL:1800 MG/M3;500 PPM EPA Rpt Qty:1 LB DOT Rpt Qty:1 LB Ingred Name:TOLUENE CAS:108-88-3 RTECS #:XS5250000 = Wt:4. OSHA PEL:SEE TABLE Z-2 ACGIH TLV:188 MG/M3;50 PPM EPA Rpt Qty:1000 LBS DOT Rpt Qty:1000 LBS Ingred Name:ACETONE CAS:67-64-1 RTECS #:AL3150000 = Wt:20. OSHA PEL:2400 MG/M3;1000 PPM ACGIH TLV:1780 MG/M3;750 PPM ACGIH STEL:2380 MG/M3;1000 PPM EPA Rpt Qty:5000 LBS DOT Rpt Qty:5000 LBS ===================== Hazards Identification ===================== Health Hazards Acute and Chronic:IRRITATION OF EYE, SKIN AND RESPIRATORY SYSTEM. MAY CAUSE NERVOUS SYSTEM DEPRESSION. EXTREME OVEREXPOSURE MAY RESULT IN UNCONSCIOUSNESS AND POSSIBLY DEATH. CHRONIC: PROLONGED & REPEATED EXPOSURE TO HE XANE MAY CAUSE DAMAGE TO NERVE TISSUE OF THE ARMS & LEGS (PERIPHERAL NEUROPATHY), RESULTING IN MUSCULAR WEAKNESS AND LOSS OF SENSATION. THIS EFFECT MAY BE INCREASED BY THE PRESENCE OF METHYL ETHYL KET ONE. Explanation of Carcinogenicity:NO INGREDIENT IN THESE PRODUCT IS AN IARC, NTP OR OSHA LISTED CARCINOGEN. Effects of Overexposure:HEADACHE, DIZZINRSS, NAUSEA, LOSS OF COORDINATION ARE INDICATIONS OF EXCESSIVE EXPOSURE TO VAPORS AND SPRAY MISTS. REDNESS AND ITCHING OR BURNING SENSATION MAY INDICATE EYE OR EXCESSIVE SKIN EXPOSURE. PROLONGED OVEREXPOSURE TO SOLVENTS IN THE INGREDIENTS SECTION MAY CAUSE ADVERSE EFFECTS TO THE LIVER, URINARY, BLOOD-FORMING, CARDIOVASCULAR & REPRODUCTIVE SYSTEM. REPORTS HAVE ASSOCIATED REPEATED & PROLONGED OVEREXPOSURE TO SOLVENTS WITH PERMANENT BRAIN & NERVOUS SYSTEM DAMAGE. Medical Cond Aggravated by Exposure:NONE GENERALLY RECOGNIZED. ======================= First Aid Measures ======================= First Aid:IF INHALED: REMOVE FROM EXPOSURE.RESTORE BREATHING. KEEP WARM AND QUIET. IF ON SKIN: WASH AFFECTED AREA THOROUGHLY WITH SOAP AND WATER. REMOVE CONTAMINATED CLOTHING AND LAUNDER BEFORE REUSE. IF IN EY ES: FLUSH EYES WITH LARGE AMOUNTS OF WATER FOR 15 MINUTES. GET MEDICAL ATTENTION. IF SWALLOWED: GET MEDICAL ATTENTION. ===================== Fire Fighting Measures ===================== Flash Point Method:PMCC Flash Point:=-17.6C, 0.F Lower Limits:0.9 Upper Limits:12.8 Extinguishing Media:CARBON DIOXIDE, DRY CHEMICAL ,FOAM. Fire Fighting Procedures:FULL PROTECTIVE EQUIPMENT INCLUDING SELF-CONTAINED BREATHING APPARATUS SHOULD BE USED. WATER SPRAY MAY BE INEFFECTIVE. IF WATER IS USED, FOG NOZZLE IS PREFERABLE.WATER MAY BE USED TO COOL CLOSED CONTA INERS TO PREVENT PRESSURE BUILD UP AND POSSIBLE AUTOIGNITION OR EXPLOSION WHEN EXPOSED TO EXTREME HEAT. Unusual Fire/Explosion Hazard:ISOLATE FROM HEAT, ELECTRIC EQUIPMENT, SPARK & OPEN FLAME.CLOSED CONTAINER MAY EXPLODE WHEN EXPOSED TO EXTREME HEAT. APPLICATION TO HOT SURFACE REQUIRE SPECIAL PRECAUTION. EMERGENCY CONDITION OVEREXPO SURE TO DECOMPOSITION PRODUCT MAY CAUSE A HEATH HAZARD. SYMPTOM MAY NOT BE IMMEDIATELY APPARENT. OBTAIN MEDICAL AID. ================== Accidental Release Measures ================== Spill Release Procedures:REMOVE ALL SOURCES OF IGNITION. VENTILATE AND REMOVE WITH HEAT ABSORBENT. ====================== Handling and Storage ====================== Handling and Storage Precautions:CONTENTS ARE EXTREMELY FLAMMABLE. KEEP AWAY FROM HEAT, SPARKS, AND OPEN FLAME. VAPORS WILL ACCUMULATE READILY AND MAY IGNITE EXPLOSIVELY. KEEP AREA VENTILATED. DO NOT SMOKE. TURN OFF ALL SOURCES OF IG NITION. Other Precautions:CONSULT NFPA CODE 30B-LEVEL 3 AEROSOL, PRODUCT 1310LEVEL 2 AEROSOLS. USE APPROVED BONDING & GROUMDING PROCEDURES. CONTENTS UNDER PRESSURE. DO NOT PUNCTURE, INCINERATE OR EXPOSE TO TEMPERATURES OVER 12 0F. HEAT FROM SUNLIGHT, RADIATOR, STOVE, HOT WATER ETC MAY CAUSE CONTAINER TO BURST. KEEP OUT OF REA CH OF CHILDREN. ============= Exposure Controls/Personal Protection ============= Respiratory Protection:IF PERSONAL EXPOSURE CANNOT BE CONTROLLED BELOW APPLICABLE LIMITS BY VENTILATION, WEAR A PROPERLY FITTED ORGANIC VAPOR/PARTICULATE RESPIRATOR APPROVED BY NIOSH/MSHA FOR PROTECTION AGAINST MATERIALS I N THE INGREDIENTS SECTION. WHEN SANDING OR ABRADING THE DRIED FILM, WEAR A DUST/MIST RESPIRATOR BY NIOSH/MSHA FOR PROTECTION AGAINST NON-VOLATILE MATERIAL. Ventilation:LOCAL PREFERED.GENERAL ACCEPTABLE IF THE EXPOSURE TO MATERIAL IN INGREDIENTS IS MAINTAINED BELOW APPLICABLE EXPOSURE LIMITS. Protective Gloves:NONE UNDLESS REPEATED EXPOSURE THEN CHEMICAL RESISTANT Eye Protection:SAFETY SPECTACLES WITH UNPERFORATED SIDESHIELDS Work Hygienic Practices:USE ONLY WITH ADEQUATE VENTILATION. AVOID BREATHING VAPOR AND SPRAY MIST. AVOID CONTACT WITH SKIN AND EYE.WASH HANDS AFTER USING. Supplemental Safety and Health ================== Physical/Chemical Properties ================== HCC:V3 Boiling Pt:B.P. Text:<0 - 395F Vapor Density:>AIR Volatile Org Content %:83 Evaporation Rate & Reference:FASTER THAN ETHER ================= Stability and Reactivity Data ================= Stability Indicator/Materials to Avoid:YES NONE KNOWN Stability Condition to Avoid:HEAT, SOURCES OF IGNITION. Hazardous Decomposition Products:CARBON DIOXIDE AND CARBON MONOXIDE. ==================== Disposal Considerations ==================== Waste Disposal Methods:WASTE FROM THESE PRODUCTS MAY BE HAZARDOUS AS DEFINED UNDER RCRA. WASTE MUST BE TESTED FOR IGNITABILITY TO DETERMINE THE APPLICABLE EPA HAZARDOUS WASTE NUMBERS. DISPOSE OF IN ACCORDANCE WITH FEDERAL, STATE, AND LOCAL REGULATIONS REGARDING POLLUTION. DO NOT INCINERATE. ===================== Regulatory Information ===================== SARA Title III Information:TOLUENE, ACETONE. State Regulatory Information:SOME OF THESES PRODUCTS CONTAIN A CHEMICAL KNOWN TO THE STATE OF CALIFORNIA TO CAUSE CANCER, BIRTH DEFECTS OR OTHER REPRODUCTIVE HARM. ======================= Other Information ======================= Disclaimer (provided with this information by the compiling agencies): This information is formulated for use by elements of the Department of Defense. The United States of America in no manner whatsoever, expressly or implied, warrants this information to be accurate and disclaims all liability for its use. Any person utilizing this document should seek competent professional advice to verify and assume responsibility for the suitability of this information to their particular situation.